Avalon 700 Spezifikationen PDF herunterladen (Seite 19)

INSERT INSTALLATION (CONT.) - For Qualified Installers Only! PAGE 19

Approved Vent Configurations

Restrictor Position

¥ A vent restrictor is

built into the

appliance to adjust

the flow rate of

exhaust gases. This

ensures proper

flames for the wide

variety of vent

configurations. The

restrictor consists of

a butterfly valve

below the starter

section of pipe and

an adjustment plate

with index holes used

to hold the valve in a

fixed position. Use

the illustrations

below to determine

the correct restrictor

position.

To Adjust the Restrictor:

The eleven holes on the

restrictor plate

correspond to the eleven

restrictor positions.

NOTE:

Position #1 is the

fully open position

Determine the correct

restrictor position (see the

charts under "Approved

Vent Configurations" - the

stock position is #1).

Remove the screw with a

1/4" nutdriver (or

screwdriver).

Rotate the adjustment plate

clockwise until the correct

index hole is below the pivot

point.

Insert the screw into the

correct index hole and

tighten.

Adjustment

Plate

1/4" Nutdriver

Index Holes

Pivot Point

This restrictor is

in Position #5.

Screw

Rotate the

adjustment

plate to change

the restrictor

position.

1' offset

(max.)

1' offset

(max.)

10' - 24'

Use restrictor position 7

Max. Ht. 30'

Min. Ht. 10'

Full Flex Re-Line Co-Axial Vent Re-Line

24' - 30'

Use restrictor position 5

10' - 16'

Use restrictor position 5

Max. Ht. 30'

Min. Ht. 10'

16' - 30'

Use restrictor position 7

Electrical Connection

¥ Plug the power cord into a grounded 120 Volt outlet (do not remove the grounding plug).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Avalon 700 Spezifikationen Seite 19

Kommentare zu diesen Handbüchern