Avalon 700 Spezifikationen PDF herunterladen (Seite 15)

INSERT INSTALLATION (CONT.) - For Qualified Installers Only! PAGE 15

Re-Routing the Power Cord to the Front (continued)

2 Carefully pull on the power cord until the molex connector is exposed. Disconnect the molex

connector.

Molex Connectors

Power Cord

Wires Leading

from the Heater

3 Pry out one of the button plugs on either side of the insert (see the illustration below).

4 Open the control cover and locate the wires leading from the power cord molex connector (green,

white, and black wires). Pull these wires forward. Insert the molex connector on the power cord

through the hole exposed in step 2 and re-connect to the molex connector on the heater. Tuck the

wire under the clip on the right side or under the gas inlet on the left side. This prevents the wire

from burning due to contact with the burner pan.

Button Plug

(found on both sides)

Remove the button

plug by prying it loose

with a screwdriver

Tuck the wire under the

clip on the right side or

under the gas inlet on

the left side.

Standard

Screwdriver

5 Secure the power cord to the heater with the strain relief (see the illustration under step 1).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Keine Kommentare

Avalon 700 Spezifikationen Seite 15