search

Avalon 700 Spezifikationen Seite 38

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 40
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
    •
  • LESEZEICHEN
    • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 37
PAGE 38 OPTIONAL EQUIPMENT (CONTINUED)
6 Re-attach the burner pan and burner box front to the burner pan box following the instructions in
step 3 in reverse order.
7 Replace the pilot assembly (follow the instructions in step 6 in reverse order). Make sure the pilot
assembly gasket is placed correctly.
8 Replace the rear log shelf (see step 2). Install the logs and embers. Replace the door.
9 Remove the regulator from the front of the gas control valve. Replace with the propane regulator,
using the new gasket and screws included with the regulator. NOTE: Leak test this area after the
heater is installed, gas is connected, and the main burner is lit.
These screws hold the
regulator in place.
NOTE: use the new
screws included with
the regulator.
Phillips
Screwdriver
PILOT ADJ
T
O
L
P
I
ON
OFF
VENT
HI
LO
VENT
HI
LO
Align the regulator
gasket so it is flat
and the two tabs fit
through the two
holes on the
gasket.
Regulator Gasket
NOTE: use the new gasket
included with the regulator.
LP (propane) regulators have a
11.0 2.8 stamped here.
NOTE: These holes strip
easily. Use a hand
screwdriver and tighten
each screw evenly.
10 Place the included propane label over the natural gas label on top of the gas control valve.
THIS CONTROL
HAS BEEN
CONVERTED TO
LP
11 Make the gas line connection, start the heater and thoroughly leak-test all gas connections
and the regulator. Check the pilot. Adjust if necessary.
The pilot flame should impinge the top 3/8Ó of the
thermopile. If it does not, you may need to turn
the pilot up.
3/8Ó
Thermopile
Pilot Hood
Thermocouple
To adjust the pilot flame, remove the cover screw (and
gasket) and turn the needle valve. Clockwise lowers
the flame while counter-clockwise raises it.
PILOT ADJ
T
O
L
P
I
ON
OFF
Standard
Screwdriver
Micro (1/16Ó)
Standard
Screwdriver
The cover screw and
gasket must be
replaced to prevent gas
from leaking
Cover Screw
Cover Screw Gasket
Needle Valve
Seitenansicht 37
1 2 ... 33 34 35 36 37 38 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare
  • ITT Teledyne Shop fox System-sensor Oliver Machinery
  • McIntosh DVD Spieler Moser Haarschneider & Haarschneidemaschine Schneider Electric Dekorative Beleuchtung Hunter Flutlichter Omega Elektrische Lebensmittelhacker
  • Acer Aspire 4820T Acer K650i Classe Audio 10 Sigma PC 26.14 Looqs MeeFrame
  • Acer Aspire G7700 Bedienungsanleitung Roland KR-377 Bedienungsanleitung Canon BX3 Datenblatt Haier DD410RS Gebrauchs- und Pflegehandbuch IKEA LAGAN Bedienungsanleitung